Page 1 of 1

driver loading/binding check

Posted: Fri Jul 25, 2014 2:52 am
by LOM
If a dongle disappears from the bus in the time frame between a successful switch and the option driver loading/bind check, then it will trigger the usage of the new_id even if the dongle is supported by option. It will furthermore throw the message about reporting the device to USB developers.

Please do a check for device still present if option driver bind fails and log it as "device no longer present on the bus" instead of the reporting to USB developers message.

Re: driver loading/binding check

Posted: Fri Jul 25, 2014 4:16 pm
by Josh
Good point; I will do that.